Jiangsu Teeyer Intelligent Equipment Corp., Ltd.
Add.: NO. 312, West Hehai Road, High Technology Development Zone, Changzhou City, Jiangsu Province, China
Tel.: +86-18206118999(Frank SHI)
+86-13861131181(David CHEN)
E-mail: sdyongfranks@teeyer.com
davidchen@teeyer.com

Cutting Section

    1. Cutting MachineAs the core equipment in an AAC production line, the cutting machine, comprising a vertical cutting device and a horizontal cutting device, can cut the AAC from all 6 sides. Thus the blocks or panels could be accurately cut into pieces with a certain dimension.
    1. Cutting CarThe AAC cutting car system works around the cutting station. It consists of a cutting car, pinion and rack moving rail. In the cutting section of the AAC production line, this cutting equipment can convey the green cake and the side plate from the turning hoist to the tilting table.
    1. Tongue and Groove Milling DeviceThe tongue and groove milling device can be used for the production of AAC block and panel. Especially in AAC panel production, this device is necessary and critical. The tongue and milling knives are hung on the pillars and can be changed with the panel type accordingly. This procedure is controlled by a PLC system.
    1. Vacuum Suction HoodThe vacuum suction hood is used to clean the waste produced during the AAC production. It is mounted on the vertical cutting machine or handing hole making machine. The vacuum suction hood is used to clean the waste produced during the AAC production. It is mounted on the vertical cutting machine or handing hole making machine.
    1. Tilting TableThe tilting table is installed at the end of the cutting section. By using this equipment, the waste material at the top and bottom of cake can be removed. The tilting table is composed by a table, guide pillar, hydraulic system, and control system.

The pre-cured concrete block in the mould will be cut into pieces as needed by the AAC cutting machine. The block appearance is largely affected by the performance of cutting machines. Due to the effective work by the subsequent machines like tongue and groove milling device, vacuum suction hood, and tilting table, each block will get 100% ready for autoclaving.